Hardware Installation





Touch screen driver installation

For resistive touch versions, follow the driver installation and calibration steps below. For PCAP touch version, no driver installation/calibration is required.

Step 1: Navigate to the installer directory to find the setup.exe file. Double-click on “setup.exe” to start installation.



Step 2: When installation starts, click Next to proceed to the next step.


Step 3: Installation in progress


Step 4: Uncheck "Install PS/2 interface driver" and click Next to continue installation.


Step 5: Check “install RS232 interface driver” and click [Next] to continue installation.


Step 6: Select option “NONE”, click [Next] to continue installation.


Step 7: When installing external USB touch monitor, please connect the USB controller and USB cable


Step 8: If there are additional touch monitors connected, please check “Support multi- monitor system”.


Step 9: Select the destination location to install the touch driver. The default path is “C: \ Program Files \ eGalaxtouch”.  Click [Next] to continue installation.


Step 10: Select the Program Folder to install the utility.  The default is “eGalaxtouch”.  Click [Next] to continue installation.


Step 11: Check the option to create a desktop shortcut icon and click [Next] to finish the installation.


For more information visit: http://bematechus.com/wp-content/uploads/2015/12/SB9015T-User-Manual-v1.4.pdf

Drivers and Utilities for SB9015T-D525

Drivers and Utilities for SB9015T-I3