SB9015T Installation Guide

Hardware Installation

Touch screen driver installation

For resistive touch versions, follow the driver installation and calibration steps below. For PCAP touch version, no driver installation/calibration is required.

Step 1: Navigate to the installer directory to find the setup.exe file. Double-click on “setup.exe” to start installation.

Step 2: When installation starts, click Next to proceed to the next step.

Step 3: Installation in progress

Step 4: Uncheck "Install PS/2 interface driver" and click Next to continue installati

Step 5: Check “install RS232 interface driver” and click [Next] to continue installation.

Step 6: Select option “NONE”, click [Next] to continue installation.

Step 7: When installing external USB touch monitor, please connect the USB controller and USB cable

Step 8: If there are additional touch monitors connected, please check “Support multi- monitor system”.

Step 9: Select the destination location to install the touch driver. The default path is “C: \ Program Files \ eGalaxtouch”. Click [Next] to continue installation.

Step 10: Select the Program Folder to install the utility. The default is “eGalaxtouch”. Click [Next] to continue installation.

Step 11: Check the option to create a desktop shortcut icon and click [Next] to finish the installation.

For more information visit: http://bematechus.com/wp-content/uploads/2015/12/SB9015T-User-Manual-v1.4.pdf

Drivers and Utilities for SB9015T-D525

Drivers and Utilities for SB9015T-I3